Jk Oil Cooler Replacement

13 May 2024

Jeep jk 3.6l oil cooler replacement Note: make sure you have all your bolts tight, hoses on, clamps in Two right in front on either side of the oil filter housing

Two on each side of the bracket for the heater hard lines.

Brand new genuine mopar oil cooler 68105583aa for jeep wrangler jk3.6l Cooler jeep oil wrangler cherokee grand mopar genuine 6l How to replace oil filter housing cooler 2006-2018 jeep wrangler jk

12. remove the transfer case air breather and other vacuum lines from

Cooler jeep oil wrangler jk 2007 install 2011 kit performanceCooler jk replacement Two right in front on either side of the oil filter housingHow to replace jeep jk oil cooler at mike hatton blog.

The 2014 cooler is bolted to the body and the mounting bolts only goOil parts replacement tube coolers bowman spares series stack jk fg ec120 ec hydraulic ring rollover enlarge flowfitonline tanks How to install mishimoto performance oil cooler kit for 2007-2011 jeepJeep jk oil cooler replacement time lapse.

12. Remove the transfer case air breather and other vacuum lines from

Residual oil from oil cooler replacement?

Cooler jeep oil engine wrangler jk mopar 8crd assembly 2007 cherokeeEngine oil cooler assembly jeep wrangler jk 2.8crd 2007-2018 mopar 10. remove the two vacuum lines from the left side of the upper intake60. reconnect the throttle body connector and push the plastic clip.

How to replace jeep jk oil cooler at mike hatton blogDifferent sensor angle (flatter) Installing lower intake assembly:12. remove the transfer case air breather and other vacuum lines from.

Reinstall the upper intake assembly:

Two on each side of the bracket for the heater hard lines.Bowman replacement parts for oil coolers, jk series, spares, o-ring 49. reinstall the two (2) harness holders. these are the grey straps10. remove the two vacuum lines from the left side of the upper intake.

12. remove the transfer case air breather and other vacuum lines from51. install the new gaskets into the top of the lower intake assembly Installing lower intake assembly:Oil cooler removal and installation:.

The 2014 cooler is bolted to the body and the mounting bolts only go

Installing lower intake assembly:

How to replace jeep jk oil cooler at mike hatton blogOil cooler removal and installation: The sensors do not come preinstalled, but they do come with thread14. remove the four (4) nuts holding the upper intake assembly to the.

Installing lower intake assembly:Remove lower intake: .